3 DIY Solar Panel Mistakes to Avoid

It is only right to expect that mistakes will be made when attempting to build DIY solar panels for the first time. This is quite normal as a person goes through a learning curve.The best scenario would to have an experienced guide point out the most common mistakes that beginners make so your can avoid them. This article attempts to do the same in other words shorten your learning curve for Energy Smart PTY Ltd.

Common Mistake #1: Improper planning and design – Number of solar cells and size of battery bank

If you have been involved with DIY construction projects this should be obvious to you. Fact is that most of us are guilty of this. We expect that our guesses and raw estimates will give us precise results. How ignorant. Think through a project’s steps, it will save you a lot of heartache.

No matter how insignifcant a step, accurate calculations are required. After all, you’ll want to have sufficient solar cells and have battery banks large enough to store precious renewable energy, isn’t it?

Common mistake #2: Constructing A Weak Solar Panel Casing

Outdoor exposure for the DIY solar panel means that it will be exposed to the elements. You therefore will need to design and build a solar panel casing that is strong enough to withstand natures elements including the wind, heat and precipitation. The problem is that most people who start out do not have a clue. A solar panel frame needs to be strong and they should have the right design and dimensions for it. Because of this many of them construct flimsy frames that cannot withstand a strong gust of wind. It may be apparent to you that solar cells can break easily. So handle them with care. The chances of the panel frame bending or breaking are quite high especially if it sin’t built storng enough.

Common Mistake #3: Solar Panels That Aren’t Sealed Properly

Over time without the right seals water vapor will seep in. Metallic parts will corrode and there are chances of mould growing as well. This is the time when some of your DIY solar panels projects break down. Therefore it is important to buy the correct type of sealant to prevent any condensation or water vapor from getting into the recesses of your solar panel.

By knowing and avoiding these 3 pitfalls, you are already on the way to building a successful DIY solar panels project. Pitfalls or mistakes may be encountered but most of them can more than likely be easily fixed. They will not promote the success of your project. It is important to remember these points when constructing your first DIY solar panel. To help avoid these and other pitfalls get the help of an experienced DIYer with this highly recommended DIY solar panels guide.